IH Turnkey CNC Mill Options

Although our CNC Mill is complete we offer 3 Performance Options.

2 HP VFD and Motor $775.00 Installed
This option allows you to run your spindle from 50 RPM to 3600 RPM. Couple this with
coolant and you can run feeds 125% faster than our standard 1750 RPM 2 HP motor.
Spindle RPM and Spindle Start and Stop are all controlled in the Gcode. You can also run the Spindle off the keyboard which is great for manual milling and rigid tapping.

NT30 Spindle $395.00 Installed
An NT30 Spindle is different than a R8 by the length of the cone type taper. The R8 taper is between .875" and .950" long versus 1.950" long NT30 taper length. This allows for much greater side loading capabilities for the tool holder (more than double), it also puts the extra load in the middle of the lower bearing, where it belongs. An added benefits is that the taper releases itself much easier for tool changes and auto tool changers. The average tool change time for an NT30 Spindle is 30 seconds by hand. Any type 30 Taper tool holder fits into our NT30 Spindle. We make custom drawbars for each type.

X & Y Axis Extensions $495.00 Installed
If you need 12.5"plus Y axis travel or 30.5"plus X axis travel, this is the way to go. For those of you who need to machine long, wide parts or to use a rotary table this is a good option. We use them with our fixture plates which are 36"x12.5". This option cannot be retrofitted to the mill, it must be installed with the original order.

Click Here For Rotary Tables
Back to Products Page

CNC & Machinery

IH Turnkey CNC Mill Options