Welcome to IH CNC Mills & Machinery

Bench Basics Part 3

Bench Basics Part 3

Back To Bench Basics Part 2
	Here is the material we used for the liner. This material is very strong and holds up very well.

	Lay out the liner. If you keep it flat around the work area it will not hole very easily.

	Tack it with a staple gun around the inside of the top edge.

	Detail of the corner .

	Trim around the top edge.

	Press down in the drain to fine the edges.

	Make the square about 1" smaller than the edges.

	Fold and staple down the edges.

	Apply a generous amount of Liquid Nails.

	Press the drain into the opening.

	Apply a generous amount of clear caulk and press it into the crack with you fingers. Repeat a few times. This caulk dries clear.
	Go To Bench Basics Part 4